Replies: 2 comments 1 reply
-
Anycubic format lacks of per layer wait time and bottom/normal wait time. |
Beta Was this translation helpful? Give feedback.
1 reply
-
Thanks for the quick response!
Understood about the printer - I'm thinking about upgrading anyway, so I'll
keep in mind that anycubic printers can't use some of these tools.
…On Fri, Mar 31, 2023 at 12:31 PM Tiago Conceição ***@***.***> wrote:
Ok found the problem and will be fixed on next patch. However keep in mind
your machine can't benefit from this to effective remove EF
—
Reply to this email directly, view it on GitHub
<#686 (reply in thread)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ABKJOG7E3AY4A6K5PSZGHDTW64WH3ANCNFSM6AAAAAAWPA7D74>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
This may be user error (in which case, I apologize), but I haven't been able to convince UVTools to apply the rest time settings correctly.
I've set them to apply whenever values are different and enabled them in settings, but "wait time after cure" isn't showing at all, and "wait time before cure" is set to 0/0, which is well outside the minimum.
I've attached all the relevant files I could think of: the original PWMO, my UVTools settings and suggestions configuration, and my Lychee Slicer scene. My printer is a Photon Mono.
uvtools.zip
Beta Was this translation helpful? Give feedback.
All reactions