origami_nvme

This project is a port of fpgadeveloper/fpga-drive-aximm-pcie for XCKU060 Origami board.
Only stand-alone applications running on Microblaze have been ported.

Requirements

• Ubuntu 22.04 (probably works on Windows)
• Xilinx Vivado/Vitis 2022.1
• Build license of Kintex Ultrascale series

Build the project

1. Open a command terminal and launch the setup script for Vivado and Vitis:

   source <path-to-xilinx-tool-install>/Vivado/2022.1/settings64.sh
   source <path-to-xilinx-tool-install>/Vitis/2022.1/settings64.sh
   

   e.g.)

   source /tools/Xilinx/Vivado/2022.1/settings64.sh
   source /tools/Xilinx/Vitis/2022.1/settings64.sh
   

2. cd into the Vivado folder of the project directory:

   cd origami_nvme/Vivado
   

3. Launch Vivado in batch mode to start the build:

   vivado -mode batch -source build.tcl
   

   After the build is complete, fpgadrv_wrapper.xsa is generated in the current directory.
4. cd into the Vitis folder of the project directory:

   cd ../Vitis
   

5. Launch XSCT to start the build:

   xsct build.tcl
   

Prepare the hardware

1. Install the SSD in the SSD1 slot of the FPGADrive and insert it into the FMC connector on the Origami board.
2. Connect the Origami board to the PC with two USB cables.
3. Turn on the Origami board.
4. Open a serial terminal at 9600 baud for USB-UART using gtkterm or screen.

Run the application

1. Connect the Origami board to the PC with two USB cables.
2. Launch Vitis and set workspace to <path-to-this-project>/Vitis/workspace.
3. Close welcome tab.
4. Press Menu Bar->Xilinx->Program Device, then press Program to write the bitstream to the device.
5. With pcie_enum_system selected from Explorer tab, press Run.
6. After a few moments, a log will appear on the serial terminal.