-
Notifications
You must be signed in to change notification settings - Fork 2
SHT31
Michel Racic edited this page Jan 31, 2017
·
9 revisions
Pullup resistors may be used to reduce noise from PSU. On the adafruit breakout they used 10kΩ on SCL, GND and SDA.
Mapping flex PCB to chip PINs
- VCC = Pin 5 (VDD) + Pin 6 (nRESET)
- SCL = Pin 4 (T)
- GND = Pin 2 (R)
- SDA = Pin 1 (RH)
- Datasheet
- Arduino library from Sensirion
- Seed Studio Datasheet and Design guidelines
- Seed Studio breakoutboard schematics and pcb design
- Seed Studio - minimal library and sample code
- Adafruit breakout guide, schematic and pcb
Sample pictures from Urs Marti
- HC SR501 Passive Infrared Sensor (PIR)
- HRLV MaxSonar EZ MB1013 Ultrasonic Range Finder
- TCRT5000 Infrared Reflective Barrier
- SHT31
- ublox PAM-7Q (GPS)
- SDP610 (Differential pressure sensor)