Diversity

DIY with 2 modules

NOTE: this feature is experimental and should be used with care

1. Set up modules

• Install custom beta firmware from http://openlrsng.org/beta/ (grab the latest)
• Use RX configurator to enable SCL and SDA outputs (from pinconfig)
• Enable the "slave mode" flag on one of the two receivers (the one going to be the slave)

2. Connecting master and slave

• Use a 4 pin cable to connect the master and slave receivers.

 SDA-SDA
 SCL-SCL
 GND-GND
 VCC-VCC or 5V-5V

3. Bind and configure the system normally. Notably the outputs on the slave are not currently usable.

NOTE: to remove the 'slave mode' flag you need to have the 'force bind' jumpper on the RX to allow it to bind.

Brotronics Broversity RX

This module has built in diversity with support for 2 antennas out of the box (it also supports a backup lipo ans buzzer for lost model finding). You can read more about it here: http://marc.merlins.org/perso/rc/post_2015-11-14_Brotronics-Broversity-RX_-the-Missing-Manual.html