Skip to content

A pulse to tone converter for the Socotel S63 rotary phone, using an Arduino Nano Every board.

License

Notifications You must be signed in to change notification settings

nm2107/S63-pulse-to-tone

Repository files navigation

Socotel S63 pulse to tone converter

The aim of this project is to create a pulse to tone converter for the Socotel S63 rotary phone, using an Arduino Nano Every board (ATMEGA4809 chip, SKU ABX00028).

⚠️ This is very much a work in progress. It is not ready yet for any usage. ⚠️

Who's there ?

Why ?

The rotary phones are composing digits by sending pulses. The amount of pulses represents the digit. However, this way to represent digits is not supported anymore by phone services, it has been replaced by DTMF (Dual Tone Multi Frequency) (the beep you hear when pressing a key). It is now this tone which represents the dialed digit.

So this project aims to convert the pulses of the rotary S63 phone to DTMF, in order to be able to use this phone again to make calls.

Really ?

Installation

Prerequisites :

  • A GNU/Linux host (other hosts are compatible too, but the documentation is GNU/Linux oriented).
  • An Arduino Nano Every board.
  • Installed softwares :
    • docker
    • docker-compose
    • git
    • make

First, clone the repo and go inside it :

$ git clone git@github.com:nm2107/S63-pulse-to-tone.git

$ cd S63-pulse-to-tone

Plug the board into your host. The board path is generally /dev/ttyACM0. If it's different, you can still specify it when running make commands by using the DEVICE var :

$ DEVICE=<path> make <target>

Make sure you have read and write accesses to the board :

$ sudo chmod o+rw /dev/ttyACM0

Then, build the docker image and install required dependencies :

$ make build install-deps

Finally, compile the app and upload it to the board :

$ make compile-release upload

If the upload task hangs with the following message :

avrdude: jtagmkII_getsync(): sign-on command: status -1

try to push the reset button on the board, and to run again the upload task.

Development

To open a shell inside the docker container, run :

$ make shell

Dependencies

Any additional dependencies should be installed via updating the install-deps make target to ensure reproducibility.

Logging

To build the app with serial logging enabled, run :

$ make compile

and then, upload it to the board :

$ make upload

You can then see the logs with :

$ make monitor

MVP Roadmap

  • Count pulses to determine the dialed digit.
  • [WIP] Generate the DTMF tone corresponding to the dialed digit.
    • See this formula to know how to compute the cutting frequency of the low pass filter. Also, the figure 7 of this link uses a low pass filer, the capacity of the components would be appropriate here too :).
  • Be able to make a call. Would make sure if the dialed digits could be sent one by one when dialing, or if they should be sent in a row at the end of the dialing (after a timeout) instead.
  • Draw electronic scheme of the final board (Arduino pins wiring, S63 wiring, and other electronic components placement) (e.g. using Fritzing).
  • Design the final board circuit in order to build it (e.g. using KiCAD).
  • [WIP] Constantly update the doc accordingly to the progresses done here.

Future enhancements

  • Support * and # dialings. May require some dialed digits combination and timeouts.
  • Put the board asleep when the phone is hung up in order to save power consumption.

Links

About

A pulse to tone converter for the Socotel S63 rotary phone, using an Arduino Nano Every board.

Topics

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published