ORIENTATION DEFINED IN NEPER NOT MATCHING IN ABAQUS PROPS #846
-
I used the following commands to generate 5 grains in neper: neper -M 2d_square.tess -statelset area -rcl 1 -elttype quad -order 1 -interface continuous -format inp -o abq_tet_2d -format msh where orientations.txt containing phi1, PHI, phi2 are as: Then, I am converting neper .msh file to abaqus .inp file using a MATLAB code. Then when viewing in ABAQUS PROPS, the angles values are not remaining same. Where am I going wrong? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
Beta Was this translation helpful? Give feedback.
-ori file(orientations.txt,des=euler-bunge)"
should be utilized to specify the input convention.-oridescriptor e
only defines the output convention.