Swipe not working properly.

[TeDeVPrime]

Hello,

i managed to install it finally on my TX Ultimate 3 relay.

The issues i have noticed so far is that if i swipe left or right.... the sensors don't get updated and they stay ON.

the worst issue with it is that if i touch the switch and try to swipe... the relays always activate.
so if relay 1 turns the light on.... and swipe up opens the cover....
when i try to open the cover, the light also turns on.

so the event of the relay action must only happen on the release and not press

[edwardtfn]

so the event of the relay action must only happen on the release and not press

Good point... I will look at that.

[edwardtfn]

I believe this is fixed in dev. I will move it to main later today.
Could you please give it a try and let me know?

[edwardtfn]

I'm reopening this as I could see the issue persists.

[TeDeVPrime]

any luck with this?

[edwardtfn]

I have some ideas for this, but couldn't work with this project recently. The latest ESPHome came with some break changes that got my attention, now I'm getting prepared to move to a new house...
But I will try to look at thin in the coming days.

[TeDeVPrime]

the latest ESPHome broke your house and now you need to move to a new one? i should stay away from that update then.

but no worries :) let me know when you have time again. enjoy your new home

[TeDeVPrime]

Hi Edward,

did you find time to check this out?
@edwardtfn

[edwardtfn]

I couldn't work at this yet, but I promise to do it later this week.
Sorry for that.

[edwardtfn]

I've finally assembled by device back, but could run only very limited tests.
Could you please give it a try and let me know the results?