Skip to content

This arduino codebase is for an mmu2 home brew clone

License

Notifications You must be signed in to change notification settings

cskozlowski/mmu2

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

76 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

DIY Multi Material Upgrade V2.0

firmware clone project

This code was developed on an Arduino Mega board using three 8825 stepper motors to control the MMU2 multi-color print head. It was designed to operate with the PRUSA mk3 printer. This code was developed to replace the stock MMU2 controller board, I got bored so I decided to create my own design. Getting it to play nicely with the mk3 was quite a challenge. This home brew MMU2 only will operate with the MK3 currently.

You will need an Arduino Mega 2560 processor board and a RAMPS 1.5 or RAMPS 1.6 shield (for the stepper motor controllers) - both are available on Amazon (see my BOM for additional details)

A serial cable is required (5 pin) in order to communicate between this board and the Mk3 controller. (Vcc, Tx, Rx, GND, Reset). Only 3 pins are required (Tx, Rx and Reset) in order to work properly with the Mk3.

WARNING:

This project is a work in progress and requires a knowledge of Mk3 hardware and software. If you don't know what you are doing, you can/will PERMANENTLY damage your hardware. I hope you have been appropriately warned.

ADDITIONAL WARNING

you probably won't read this because it is too far down the page:

Stepper Motor controllers (8825) are high current devices and they get warm/hot. You can damage these controller easily (I have) if you don't adjust the source current. There is a very small variable resister you will have to adjust, I recommend setting this to 0.6V (details on how to adjust this are on the polulu.com website - look for 8825 stepper motor controller). If you don't have a multimeter for measuring voltage then STOP - you are in deep waters.

TODOs

  • Document Pinouts for each of the stepper motors
  • Document Pinouts for 2 sensor cables
  • Document Pinouts for Cable between MMU2 controller and MK3 controller (TX, RX, Reset, Vcc)

About

This arduino codebase is for an mmu2 home brew clone

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages