-
|
Please excuse my ignorance but am very much a novice with these things. I have just fitted a BTT TFT35 touchscreen to my ender3 pro and all appears to work fine except every time I switch on my printer I get an error message that says 'Failed to enable bed levelling'. I can clear this and all seems fine but how do I stop this message from occurring. I have no level sensor fitted and have not as yet done any mesh bed levelling?? |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
Set in the cinfig.ini file. If you want to achieve good results, I recommend using some kind of leveling... |
Beta Was this translation helpful? Give feedback.
-
|
Thank you very much for that all now sorted. |
Beta Was this translation helpful? Give feedback.
-
|
...or you can switch this option off on the TFT itself going to Menu -> Settings -> Feature where you'll find the "Auto Save Load Leveling" option which can be switched on and off... |
Beta Was this translation helpful? Give feedback.
-
|
Thanks now I know 2 ways😀
…Sent from my iPhone
On 1 Jan 2023, at 15:29, kisslorand ***@***.***> wrote:
...or you can switch this option off on the TFT itself going to Menu -> Settings -> Feature where you'll find the "Auto Save Load Leveling" option which can be switched on and off...
—
Reply to this email directly, view it on GitHub, or unsubscribe.
You are receiving this because you authored the thread.
|
Beta Was this translation helpful? Give feedback.
Set in the cinfig.ini file.
auto_load_leveling:0
If you want to achieve good results, I recommend using some kind of leveling...