-
-
Notifications
You must be signed in to change notification settings - Fork 5.3k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Extruder steps differ due to pressure at higher speeds #2711
Comments
Hi @trollkarlen, It did not look like there was a Klipper log file attached to this ticket. The log file has been engineered to answer common questions the Klipper developers have about the software and its environment (software version, hardware type, configuration, event timing, and hundreds of other questions). Unfortunately, too many people have opened tickets without providing the log. That consumes developer time; time that would be better spent enhancing the software. If this ticket references an event that has occurred while running the software then the Klipper log must be attached to this ticket. Otherwise, this ticket will be automatically closed in a few days. For information on obtaining the Klipper log file see: https://github.com/KevinOConnor/klipper/blob/master/docs/Contact.md The log can still be attached to this ticket - just add a comment and attach the log to that comment. Best regards, PS: I'm just an automated script, not a human being. |
A little in the same ball park as #2610.
Its not only hotend issue(it can be) but a fluid dynamics problem that can
be compensated for so higher speed prints get better quality.
//T
…On Sat, Apr 11, 2020, 19:33 Hywelmartin ***@***.***> wrote:
#2707 <#2707> looks like
the same... get a hotend that support the mass flow you are trying to
extrude
#2610 <#2610>
—
You are receiving this because you were mentioned.
Reply to this email directly, view it on GitHub
<#2711 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAAWIHDKCCAJNIJ55CXHIS3RMCSWVANCNFSM4MF53UNA>
.
|
As indicated this looks like a dup of #2610. -Kevin |
I'm going to close this in favor of the existing #2610 . -Kevin |
Sounds good.
//R
…On Fri, Apr 24, 2020, 16:44 KevinOConnor ***@***.***> wrote:
Closed #2711 <#2711>.
—
You are receiving this because you were mentioned.
Reply to this email directly, view it on GitHub
<#2711 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAAWIHDQXDQ4D77Z4Y6O4RDROGQTBANCNFSM4MF53UNA>
.
|
Is this correct due to the extruder getting too cold or is it something that can be compensated with like pressure advance ?
Maybe its something that can get manual help to the physics with a settings in config like
step_distance: 0.00975
step_distance_500: 0.00935
//T
The text was updated successfully, but these errors were encountered: