Unable to upload blink program, Error: No debug probe detected.

[Murugesh-Hobbyist]

I'm using the below board.
https://robu.in/product/stm32f401ccu6-minimum-system-board-microcomputer-stm32-arm-core-board/

Program I tried to upload
void setup() {
pinMode(B10, OUTPUT);
}

void loop() {
digitalWrite(B10, HIGH); delay(1000);
digitalWrite(B10, LOW); delay(1000);
}

Resulted monitor while upload,
Sketch uses 10816 bytes (4%) of program storage space. Maximum is 262144 bytes.
Global variables use 880 bytes (1%) of dynamic memory, leaving 64656 bytes for local variables. Maximum is 65536 bytes.
-------------------------------------------------------------------
STM32CubeProgrammer v2.17.0
-------------------------------------------------------------------
Error: No debug probe detected.

Expected behavior
Upload completed

Obtained result below.

Desktop (please complete the following information):

• OS: Win 11
• Arduino IDE version: 2.3.2
• STM32 core version: 2.8.1
• Upload method: SWD

Board (please complete the following information):

• Name: STM32F401CCU6

Please excuse if its a asimple solution. I read through the forums for hours with no hints.
I registered my acccount with stm32duino forum but seems it will take time for ur team to approve my request. so there will be a delay to raise this question. so I posted here. please help.

[fpistm]

You need a STLink with swd....

[Murugesh-Hobbyist]

ok without that can't we program through arduino IDE usb port?

if not, please confirm can i go for the below module because i dont understand (with swd)
https://robokits.co.in/programmers/stm32-stm08/st-link-v2?srsltid=AfmBOoo4_15jBD33fjKG5VXDqYEF17bYOcMwSMalkQx2xBSqUXfJuq2Va0E

[fpistm]

You can use dfu but you have to enter in dfu mode before upload.

[Murugesh-Hobbyist]

can you please suggest any video link/docs for the same?
if entering dfu is an option without any additional harware, is there any reason for you to suggest stlink?

[fpistm]

No reason to suggest STLink, just you error was "Error: No debug probe detected." so I simply answered why you get this issue.
About DFU, I guess you need to press Boot 0 button before plug usb cable.