-
Hello, Since I would like to improve my printing time, I wonder until how many I can set the max speed within the uvtools_acceleration.gcode file instead of the original 240 mm/mn ? Do you think I can try with 480 mm/mn for a Saturn ? More than this ? Less ? Cordially, |
Beta Was this translation helpful? Give feedback.
Replies: 4 comments 13 replies
-
You can try more speed, but i think its worthless. What you can do is increase acceleration, too bad they dont support decimals, so I1 would go to I2, and thats the double of acceleration. |
Beta Was this translation helpful? Give feedback.
-
Hello, |
Beta Was this translation helpful? Give feedback.
-
I was pretty happy, ready to come back here to say "Hurra, 120 mm/s² acceleration in gcode file does the job !" BUT alas, if I tried with success on 2 Saturn printers, the third did not print all the parts (3 parts/8 did stay on the FEP). |
Beta Was this translation helpful? Give feedback.
-
I have finally the answer : 60 mm/s² is that good ! 😊👍 |
Beta Was this translation helpful? Give feedback.
I have finally the answer : 60 mm/s² is that good ! 😊👍