Skip to content

Latest commit

 

History

History
24 lines (18 loc) · 1.89 KB

README.md

File metadata and controls

24 lines (18 loc) · 1.89 KB

BRS Testbed

A simple Roku channel used to execute arbitrary BrightScript files.

Justification

This repo contains a Roku channel that shouldn't ever be published to the Roku store. That's pretty silly on the surface! In reality, this project exists purely to answer TODOs and other questions from the BRS project, which aims to build a BrightScript interpreter that runs on non-Roku platforms. A small test channel like this one helps to observe behaviors that are described ambiguously in the BrightScript documentation. After all, a BrightScript interpreter is only useful if it behaves the same way as the official interpreter 😄.

Hacking

Building

The channel builds with GNU Make, but that's just a wrapper around zip. Build with make, and remove compiled artifacts with make clean.

Adding Test Files

Test files are hosted in ./testfiles/, and should keep their code in a sub Main block. That's not strictly required, but it helps to isolate test files from each other.

NOTE: The list of files available to run is not generated automatically, so adding a new test file requires a modification to Main.xml to point to it. Simply add another <TestFile> element like the ones that already exist.

Installing

  1. Ensure your Roku has developer mode enabled. If you're not sure, go through Roku's Setup Guide again.
  2. Find your Roku's IP address from Settings > Network > About.
  3. Navigate to http://roku.ip.addr.ess in your browser and enter the username/password you set previously.
  4. Click "Upload", then "Install" or "Replace".
  5. The "BRS Testbed" channel will automatically launch (assuming there were no compile errors).

Debugging

Use telnet to connect to your Roku's IP address on port 8085 to see the output of any print commands in the testfiles files.