You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When a print is complete, a popup showing "Print Completed [time] ... [OK]" would come up.
Some times it doesn't.
The printer will be stuck in printing mode, showing progress 100%.
Because of this, you cannot move axes, filament, or start another print.
If you click [Pause], the printer errors out. (failed to get response from pause command)
If you click [stop], the pop up appears and the print is completed.
Note: The g-code file is indeed complete because the last line was executed (M104 S0).
I notice this only happens on consecutive prints. It never happens on a first print after power on.
Steps to Reproduce
Print from SD card from root folder.
Start a print.
Wait till it completes. Then start another print
Wait till it finishes at 100% and stop.
Expected behavior: [What you expect to happen]
The print finishes and a popup occurs in the screen.
Actual behavior: [What actually happens]
The print stays at 100% progress.
The printer does not respond to [pause] button.
Additional Information
This can be tested with single line g-code file.
It never happens on first print after power up. However, sometimes it doesn't happen on a second print either.
Bug Description
When a print is complete, a popup showing "Print Completed [time] ... [OK]" would come up.
Some times it doesn't.
The printer will be stuck in printing mode, showing progress 100%.
Because of this, you cannot move axes, filament, or start another print.
If you click [Pause], the printer errors out. (failed to get response from pause command)
If you click [stop], the pop up appears and the print is completed.
Note: The g-code file is indeed complete because the last line was executed (M104 S0).
I notice this only happens on consecutive prints. It never happens on a first print after power on.
Steps to Reproduce
Expected behavior: [What you expect to happen]
The print finishes and a popup occurs in the screen.
Actual behavior: [What actually happens]
The print stays at 100% progress.
The printer does not respond to [pause] button.
Additional Information
This can be tested with single line g-code file.
It never happens on first print after power up. However, sometimes it doesn't happen on a second print either.
Machine: stock i3 mega-s
Firmware: MEGA_S_v1.5.2.hex (prebuilt release)
The text was updated successfully, but these errors were encountered: