[FR] Smart Filament Sensor Module with Repetier-Firmware V2

[GenaUser]

Would it be possible to add sensor management for the Repetier-firmware V2?
https://github.com/repetier/Repetier-Firmware/tree/dev2

Information sent by the firmware:
GCodeSource :: printAllFLN (PSTR ("// action: out_of_filament T"), (int32_t) tool-> getToolId ());
GCodeSource :: printAllFLN (PSTR ("RequestPause: No filament detected!"));

It would also allow the use of smart filament sensors from multiple extruders connected to the board.
Thank you in advance to analyze this possibility.

[traffic-light]

This screen is marlin, and not reptier, firmware based.

So I don't think it will be imported. To do that the complete firmware of the tft would need to be rebuild...

But maybe someone with more knowledge of reptier can give a better answer

[GenaUser]

@traffic-light
Since their creation, these screens are perfectly compatible with Repetier-Firmware V1 or V2, whether in "Touch mode" or "Marlin mode".
My request concerns only the additional interpretation of the Gcode sent when an absence of the filament is detected.

[traffic-light]

I'm sorry. My fault.

[oldman4U]

Hello GenaUser.

Could you please be so kind and close this ticket. Your feature request is covered in the pinned Feature Request ticket #1170

Thank you

[github-actions]

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.