Replies: 1 comment
-
So, I went back a few steps and viola, all seems to be the way it is supposed to be. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I just took the latest from the bugfix branch and ran into a problem.
During the flash it complains about tft_lcd_delay=4 not found, but finishes to upload.
After upload, I ran a Z axis level and following a AutoBedLevel (BL Touch original).
Does that too, but never asked me to save the values to eprom? All I get a triple beep. Used to show a save dialog.
Next, I do a probe offset, set it and don't get the "save" dialog either?
So, I use the terminal to M500. Responds (of course all is AOK).
When I come back to the regular screen, the notification say, ALL AOK?
Now, I want to print... from TFT sd card.
My GCODES are listed, beeps on selection, but that's as far as it goes.
Also, I tried to compile my own binary, without success, same error "Lcd_Delay" reassigned or something like that.
Compile failed!
ONBOARD SD doesn't even bother to display the contents.
Did I screw up something in the config.ini or did I just run across a severe bug?
My best guess is, either my TFT went into silicon heaven or it is the TFT firmware.
Perhaps someone else has a similar or same experience?
I actually went back to the release version, however, it still complained about the LCD_Delay, might have been my mistake since the config has changed.
Coincidentally, my PC went haywire at the same time, but recovered with a screwed up SD card.
Beta Was this translation helpful? Give feedback.
All reactions