Replies: 3 comments
-
Same EXACT thing is happening to me. Did EVERYTHING. Can't tell you how much time was wasted building and research different message boards and youtube videos. Good luck on this and I'll be monitoring as well should anyone have a suggestion outside of the normal "try switching the baud/port/FULL_GRAPHIC" comments that always show up. |
Beta Was this translation helpful? Give feedback.
-
In the end i did it. I set ports to 0 and -1 and baudrato to 250000... but im unable to force ESP-01 to conncet to printer... when i set port to 3, then the FTF dont connect to printer again... glitchy... |
Beta Was this translation helpful? Give feedback.
-
For all users reading this discussion. Please read the Readme at the front page of this repository. There you find everything related to connecting the TFT. No printer attached: Correct serial port defined in Marlin (mainbord dependent) and matching baudrate. Marlin Emulation is empty: correct display type defined in Marlin. |
Beta Was this translation helpful? Give feedback.
-
Hello,
i done everything, updated firmware, try all ports and baudrates but my TFT 35 still show No printer attached. Im using TFT conector only. I got set in marlin 2 ports, -1 and 0, also REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER but still it doesnt work. Is my tft broken?
Beta Was this translation helpful? Give feedback.
All reactions