Filament runout sensor #1480
Unanswered
gerthalberg
asked this question in
Q&A
Replies: 3 comments 7 replies
-
According to kisslorand, you have to add a "M75" to your start gcode of the slicer or the TFT to make this work. But this is less a discussion than an Issue and you should check existing open and closed issues first. Hope this helps |
Beta Was this translation helpful? Give feedback.
2 replies
-
Don't do that!!! |
Beta Was this translation helpful? Give feedback.
2 replies
-
what board have you got? |
Beta Was this translation helpful? Give feedback.
3 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
It seems like when you run the tft in Marlin mode there will be a reaction when the filament runout switch is triggered. This is not the case when running in BTT/touch mode - unless the runout switch is connected to the tft. The question is would it be possible to have the same switch connected to both the board and the TFT at the same time? probably with a y-splitter. My board is SKR 1.4 Turbo and TFT is TFT35 E3 V3.
Beta Was this translation helpful? Give feedback.
All reactions