motion masks / zones: not working? #12696
Replies: 2 comments 3 replies
-
|
There are two issues here:
|
Beta Was this translation helpful? Give feedback.
-
|
Hi Nick - thanks for a quick response. On item 1: I can add this to the snapshot section of the config for camera? On item 2: what is the guidance to prevent this? I pulled back my required zones and the object mask for what I think is far enough. That pinwheel causes 500 events a day. Sure would like to reduce that. |
Beta Was this translation helpful? Give feedback.
-
|
Beta Was this translation helpful? Give feedback.
-
|
Even though it's not directly related to the original question: would it make sense to add a motion mask along the left side of the camera frame, i.e. to mask out what is presumably the structure (house) to which the camera is attached? Since this is an area where it's basically impossible for typical objects-of-interest to appear/originate? It might save a few CPU cycles since there's likely shadows and leaves blowing around. |
Beta Was this translation helpful? Give feedback.
-
|
Most likely though if that's a window theoretically a person could be there |
Beta Was this translation helpful? Give feedback.
-
Describe the problem you are having
I assume I am doing something wrong. I have 2 zones in my backyard. I have a pinwheel that keeps being detected as a person even though it's out of the required zone and I have a motion mask over it as well. I've read through documentation and think I have everything set right. If not I don't understand what I'm missing.
Version
0.13.2-6476f8a
Frigate config file
Relevant log output
FFprobe output from your camera
Frigate stats
n/aOperating system
UNRAID
Install method
Docker Compose
Object Detector
TensorRT
Network connection
Wired
Camera make and model
reolink 520
Any other information that may be helpful
No response
Beta Was this translation helpful? Give feedback.
All reactions